Mass trick repeating element

If you create a mass and you would like an adaptive component family to repeat over it’s edges you might end up with some unwanted results. 


Adaptive component family with 4 points and a little trick to keep the slanted ones in place

 starting situation: a mass which adges were divided by selecting grid lines to do the division

 first try: Place the frame, I tend no to use the first point in a division. I have some selection issues sometimes. Press the repeat button. (it’s the one that looks like array with a red small P. Notice the cute little knot in the image below? It seems as I have experienced in other models and families that any line has a direction which so far I have not been able to revert. 

adjustment to make it work: Add a second one next to the first. Select them both and press the repeat button again.

 desired outcome

Next up, create part and assemblies

Disclaimer information
http://danielgijsbers.blogspot.com/2012/08/disclaimer.html

Mass trick repeating element

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

If you create a mass and you would like an adaptive component family to repeat over it’s edges you might end up with some unwanted results. 


Adaptive component family with 4 points and a little trick to keep the slanted ones in place

 starting situation: a mass which adges were divided by selecting grid lines to do the division

 first try: Place the frame, I tend no to use the first point in a division. I have some selection issues sometimes. Press the repeat button. (it’s the one that looks like array with a red small P. Notice the cute little knot in the image below? It seems as I have experienced in other models and families that any line has a direction which so far I have not been able to revert. 

adjustment to make it work: Add a second one next to the first. Select them both and press the repeat button again.

 desired outcome

Next up, create part and assemblies

Disclaimer information
http://danielgijsbers.blogspot.com/2012/08/disclaimer.html

Mass trick repeating element

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: